MPI für Physik / MPI für Physik |
|The ATLAS semiconductor tracker end-cap module|
|Authors:||Abdesselam et al, A.|
|Date of Publication (YYYY-MM-DD):||2007|
|Title of Journal:||Nuclear Instruments and Methods in Physics Research Section A|
|Issue / Number:||575|
|Intended Educational Use:||No|
|Abstract / Description:||The challenges for the tracking detector systems at the LHC are unprecedented in terms of the number of channels, the required read-out speed and the expected radiation levels. The ATLAS Semiconductor Tracker (SCT) end-caps have a total of about 3 million electronics channels each reading out every 25 ns into its own on-chip 3.3 micro seconds buffer. The highest anticipated dose after 10 years operation is 1.4*10^14 cm^-2 in units of 1 MeV neutron equivalent (assuming the damage factors scale with the non-ionising energy loss). The forward tracker has 1976 double-sided modules, mostly of area 70 cm^2, each having 2×768 strips read out by six ASICs per side. The requirement to achieve an average perpendicular radiation length of 1.5% X0, while coping with up to 7 W dissipation per module (after irradiation), leads to stringent constraints on the thermal design. The additional requirement of 1500e- equivalent noise charge (ENC) rising to only 1800e- ENC after irradiation, provides stringent design constraints on both the high-density Cu/Polyimide flex read-out circuit and the ABCD3TA read-out ASICs. Finally, the accuracy of module assembly must not compromise the 16 micrometer (rPhi)resolution perpendicular to the strip directions or 580 micrometer radial resolution coming from the 40 mrad front-back stereo angle.|
A total of 2210 modules were built to the tight tolerances and specifications required for the SCT. This was 234 more than the 1976 required and represents a yield of 93%. The component flow was at times tight, but the module production rate of 4050 per week was maintained despite this. The distributed production was not found to be a major logistical problem and it allowed additional flexibility to take advantage of where the effort was available, including any spare capacity, for building the end-cap modules. The collaboration that produced the ATLAS SCT end-cap modules kept in close contact at all times so that the effects of shortages or stoppages at different sites could be rapidly resolved.
|Classification / Thesaurus:||ATLAS|
|External Publication Status:||published|
|Affiliations:||MPI für Physik|
The scope and number of records on eDoc is subject
to the collection policies defined by each institute
- see "info" button in the collection browse view.